Forum Replies Created
-
AuthorPosts
-
water4uMember
I agree, Flouride has been added to municipal water for the its benefit of forming strong teeth. However, if the flouride levels are too high (US EPA says over 2mg/l) it causes tooth molting and ugly brown/yellow stains. There are some informative articles found at http://www.flouridealert.org
water4uMemberI am currently researching the CR drinking water standards and compliance. In the US for example one can simply visit EPA’s website and go to drinking water standards. The public right to know was a measure passed in Clinton’s Administration that allowed the public to access drinking water compliance data. In Oregon, the State has a public access data base that has every public water system and the water analysis including violations. I will be looking into the CR regulations and will most likely compile some data for our webisite in the future. My primary markets are private wells, springs, and surface water sources. Where we will conduct analysis then design, install and service treatment systems. I will endeavor to get an answer to your question and post it.
water4uMemberThanks Scott, municipal (community) water systems are regulated by the Gov., however I provide equipment for the homeowner (drinking water units, whole house purification etc.) I am still looking for feedback on good homebuilders.
water4uMemberI also have a question about this. I would like to travel via Dual-Sport Motorcycle. Any comments?
-
AuthorPosts